< < Back to Vertical-Horizontal Dynamometers Page

Vertical-Horizontal 5 to 75hp Tilt Stand

The illustration below shows the typical configuration for the two-position small engine tilt stand. Dimensions are not given because they will change as different dynamometer models are used. The chart lists various models that can be used in this type of test stand. Note: Only Dry Gap models can be configured vertically.

Line drawing of typical 5 to 75 horsepower dynamometer tilt stand
Line Model # HP Speed (RPM) Inertia (LB*FT2) Max Torque (LB*FT)
Midwest 3HS 5 3600/18,000 0.04 7.3
Midwest 46 10 3000/7000 0.14 17.5
Midwest 46HS 10 3000/12,000 0.14 17.5
Midwest 48HS 20 2900/18,000 0.24 36.2
Midwest 66 30 3000/6000 0.75 52.5
Midwest 66HS 30 3000/12,000 0.75 52.5
Dynamatic 66DG 40 3300/6000 0.75 63.7
Dynamatic 66DGHS 40 3300/12,000 0.75 63.7
Midwest 758 50 2000/6000 3.6 131.3
Midwest 758HS 50 2000/12,000 3.6 131.3
Dynamatic 8060 75 3400/12,000 1.4 115.9
Dynamatic 8060HS 75 3400/16,000 1.4 115.9
Dymond AC Various 15 to 40 See Brochure See Brochure See Brochure

Top view of portable small engine test stand in lowest position
Top view

Portable Multi-Position Fractional to 40 hp Test Stand

Simulate Engine's (or Motor's) Real-Life Operating Angles

This test stand differs from the two-position model shown above, offering a large variety of shaft angles. View an animation of some of the possible angles.

Virtually any Dry Gap dynamometer model up to 40hp may be used in this small engine test stand. Please refer to the chart above. The dimensions of this portable ”cart” vary depending upon the size of the dynamometer.


For More Information