Standalone Eddy Current and Throttle Power Amplifier

<< PAU Home

Dyne Systems standalone combination eddy current and throttle position PAU

Dyno and Throttle PAUs In One Box - LabVIEW Compatible

Dyne Systems has combined its DS820 Eddy Current PAU and DS830 Throttle PAU in a single unit configuration. This unit can operate as a standalone unit or interface with external analog and digital control interfaces. Combining both the Eddy Current PAU and Throttle PAU into a single rack enclosure affords additional rack space, as it is half the size of separate controllers. Separate LCD display panels allow each control to be setup and monitored independently.

Two user manuals are needed for this Combo EC and Throttle PAU.

pdf logoDS820E Standalone Eddy Current PAU User Manual.

pdf logoDS830A Standalone Throttle Position PAU User Manual.

For your convenience, an overview of the features of both PAUs are listed below. Following the links in the above paragraph will take you to their detailed pages.

Features of the DS820 Eddy Current PAU

  • Interfaces with all existing DyneSystems dyno controllers and most competitors' controls
  • LabVIEW™ compatible
  • Stand-alone operation supported
  • LCD diagnostic readouts display field current, input command, and PAU status and faults
  • 0 to +10 VDC control input
  • Dry contact and PCL-Level I/O
  • Rack-mount units up to 30A and 277 VAC
  • Wall-mount units up to 200A and 480 VAC
  • Advanced fault detection (e.g. blown fuse, incorrect transformer phasing and other wiring errors)
  • Integral safety inputs included
  • Simple setup and calibration

Features of the DS830 Throttle PAU

  • LCD display shows:
    • Controller status
    • State
    • Commanded position
    • Actual actuator position
    • Possible fault information
  • Complete standalone operation or simple integration into customer control system
  • Convenient connection to external controller via Sub-D connectors
  • 0 to +10 VDC and 0 to +20 mA input command accepted
  • 0 to +10 VDC position command output
  • PLC-level (+24 VDC) digital control inputs and status outputs
  • Fault detection (actuator stall, power fail, etc.)

For More Information